ALPHA-DENT ® LIGHT CURE BONDING ADHESIVE
Light Cure Bonding Adhesive
Country of Origin : USA
KIT CONTAINS:
2 x 3mL BONDING ADHESIVE
7mL ETCH LIQUID
DISPENSING PAD
BRUSHES
PRODUCTS DETAILS
Alpha-Dent® Light Cure Bonding Adhesive is designed for bonding composite resin materials to dentin and enamel. The ideal viscosity allows the material to penetrate into microtubules to enhance mechanical adhesion.
INSTRUCTIONS FOR USE
1. Prepare the tooth. Isolate and dry the tooth thoroughly.
2. If using Alpha-Dent ® Etchant or Alpha-Etch37 ® etch enamel for 15 seconds or if applied to dentin etch for 10 seconds; never leave etchant on tooth for longer than 60 seconds. Lightly agitating the etchant during its application can enhance its action.
3. Rinse thoroughly with water and the tooth must be dried completely. The dry etched surface should appear dull and frosty white. If the surface to be etched does not, then repeat step 2.
4. Dispense two drops of Alpha-Dent ® Light Cure Bonding Adhesive onto a dispensing pad or other suitable surface. Thoroughly saturate a brush tip and generously apply one uniform layer onto the prepared tooth.
5. Using a visible light-curing unit (minimum output of 600 mW/cm ) cure the bonding adhesive for 20 seconds. The surface should be glossy. If not, repeat steps 4 through 5.
6. Place the light cure restorative material over the cured Alpha-Dent ® Light Cure Bonding Adhesive . Refer to manufacturer’s instructions for placement, cure, and finish of the restorative material.
